Each sandbox instance connect to different network adapter

oomin

New member
I have 3 different network adapter on my pc. Is there a way for each sandbox instance to specify which network adapter to connect to?
 
Yes, starting with Sandboxie Plus 1.15.10 you can that by IP:

Quoting the changelog:
Added 'BindAdapterIP=192.168.100.123' and/or 'BindAdapterIP=::ffff:c0a8:647b' to force sandboxed programs to use a defined host IP
  • Note: if the IP is not bound to one of the hosts NICs the connections will fail
  • the configuration can be set per process like 'BindAdapterIP=program.exe,192.168.100.123', but only in the INI, not in the UI

There is no user interface for this setting.

With Sandboxie Plus 1.15.12 it will be possible to specify the adapter:
instead of binding to IP, Sandboxie can now bind to adapter (resolving IPs at WSA_Startup)
 
The problem is the program I am using inside sandbox currently will only run in 1.15.9. It failed to start on 1.15.10 and 1.15.11.

I reported the problem here as it was a test continuation to the topic
 
Sandboxie Plus 1.15.12 is supposed to fix issues that seem to have been introduced in 1.15.10, maybe that includes your issue(s) as well.
 
Sandboxie Plus 1.15.12 is supposed to fix issues that seem to have been introduced in 1.15.10, maybe that includes your issue(s) as well.
You are correct, it works now, but when I specify one of the sandboxes to bind to a network adapter, I keep getting disconnected after couple hours. When I turned off the bind, then working fine.

About the sponsor, do you only offer monthly charges? No annual one?
 
I keep getting disconnected after couple hours.
I am not sure how often this feature has been used and for how long, so that there are either no reports because no one else is affected or the just have not encountered it yet.

About the sponsor, do you only offer monthly charges? No annual one?
For questions about the payment methods, you better reach out to David, via e-mail.
 
Back
Top